How-to-guides for the EVIE S1 and T1.
Flip the bicycle upside down with soft padding on the display. Take off the spiral cable wrap at the bottom part of the frame. Remove the cable tie on the bike frame. Unplug the hub motor connector. Remove rubber caps on both sides of the rear wheel.
Flip the bike upside down. Free all the cables from the spiral cable wrap. Unplug all the cables. Flip the bike upright. Loosen up the three hex cap screws at the bottom front of the frame near all the cables with a 3mm Allen key. Flip the bike upsid
Loosen the quick-release skewer on the front wheel. Remove the front wheel by detaching it from the fork. Free the cables from the metal clip below the front fender. Carefully unplug the cable. Use a 7mm size wrench and a 2mm Allen key to remove the
Open the spiral cable wrap under the handlebar. Unplug the two cables under the handlebar. Loosen up all four screws underneath the handlebar by using a size #1 Philip screwdriver. Gently push the USB cover from below the handlebar until the display
4mm Allen Key. 5mm Allen Key. 18mm Wrench. #1 Philip Screwdriver. Use 4mm Allen key to remove four screws that mounts the lock to the frame of the bicycle. Gently unplug the connector of the lock. Flip the bicycle upside down with soft padding on the
4mm Allen Key. Make sure the lock the unlock state. Use a 4mm Allen key to remove four screws that mount the lock to the frame of the bike. Gently unplug the connector of the old lock. Plug the connector of the new lock.
#0 Philip Screwdriver. 3mm Allen Key. Flip the bike upside down. Free all the cables from the spiral cable wrap. Unplug all the cables. Flip the bike upright. Loosen up the three hex cap screws at the bottom front of the frame near all the cables wit
Flip the bicycle upside down with soft padding on the display. Take off the spiral cable wrap at the bottom part of the frame. Gently unplug the torque sensor connector. Use an 8mm Allen key to remove the left and right crank bolts. 1. Use 16mm wrenc