Replacing the battery (S1 and T1)Updated a year ago
What You Need
#0 Philip Screwdriver | |
3mm Allen Key | |
Battery |
Step 1
Flip the bike upside down.
Step 2
Free all the cables from the spiral cable wrap.
Step 3
Unplug all the cables.
Step 4
Flip the bike upright.
Step 5
Loosen up the three hex cap screws at the bottom front of the frame near all the cables with a 3mm Allen key.
Step 6
Flip the bike upside down again.
Step 7
Carefully remove the motor controller and the attached battery from the bike's frame.
Step 8
Loosen up the four-pan head screw between the battery and the motor controller with Philip's head screwdriver size #0.
Step 9
Test the new battery using the charger, making sure that the battery is in good condition (light turns red when charging).
Step 10
Install the new battery with the motor controller with the four pan head screws.
Step 11
Slowly insert the new battery along with the motor controller into the frame.
Step 12
Install the new battery into the frame with the three hex cap screws earlier using the 3mm Allen key.
Step 13
Plug in all the cables according to their correct pairing.
Step 14
After all the cable is plugged in together correctly, wrap all the cable together with the spiral cable wrap.
Step 15
Flip the bike back upright and the process is complete.