Replacing the handlebar display (S1 and T1)Updated a year ago

What You Need 

	#1 Philip Screwdriver
	Display Module

Step 1 

Open the spiral cable wrap under the handlebar. 

Step 2 

Unplug the two cables under the handlebar. 

Step 3 

Loosen up all four screws underneath the handlebar by using a size #1 Philip screwdriver. 

Step 4 

Gently push the USB cover from below the handlebar until the display module pops up to remove the display module. 

Step 5 

Make sure the USB slot and the cables are in the right hole and insert the new display module into the slot. 

Step 6 

Reattach all four screws underneath the handlebar using the #1 Philip screwdriver.

Step 7 

Plug all the cables back underneath the handlebar. 

Step 8

Plug all the cables back underneath the handlebar.

Step 9 

Check the display module if it's working using the button on the left side of the handlebar. Make sure there is no "Error" message showing on the display screen.